PRODUCT CARE & INSTRUCTIONS

BUBS EAT

We highly recommend to hand wash all our silicone feeding products (if necessary, it is safe to wash on the top rack of a dishwasher). Please only use soap that does not contain antibacterial agents, essential oils or moisturisers.

For foods that can stain, wash immediately after use.

SUCTION BOWLS & PLATES
Ensure surface is flat and clean. Press down onto the surface to ensure air pockets are removed for effective suction. To remove use tab to lift up. For extra stick, lightly wet the suction on the bottom and then press down onto the surface. 

PLACEMATS
Ensure the tray is flat and clean. Matte side on top and gloss side on the tray. 

HIGHCHAIR FOOTRESTS

  • Remove both front highchair legs
  • Loosen all clamps and slide 1 clamp first, then 1 o-ring on each leg leaving a gap
  • Secure legs back on highchair
  • From a diagonal angle, place the footrest in the gap between the clamps and o-rings
  • Adjust the footrest to the suitable height for your child so that their hips, knees and legs are on a 90 degree angle
  • Tighten the clamps below the footrest and slide the o-rings firmly into place so it sits above the footrest to secure it
  • Includes 2 clamps and 2 thick rubber o-rings. Extra set of clamps and o-rings are available for purchase for spare or wear and tear
  • Product Care: footrest - simply wipe down with water. Regularly maintain clamps and o-rings are secured and safely out of reach of children

Note: When clamps are tighten the amount of pressure over time may cause scratches to the highchair legs or our pre-cut leg wraps.

Safety Warning: Footrests should always be used with the highchair safety harness and buckle fastened tight. Always supervise children whilst in the highchair and do not leave them unattended, as they may use the footrest to stand up and push themselves out of the seat. Clamps and o-rings may be a choking hazard, keep out of reach of children.

PRE-CUT LEG WRAPS FOR IKEA ANTILOP HIGHCHAIR

  • Remove and clean all highchair legs
  • Place legs on flat surface with 2 legs facing up and 2 legs facing down
  • Start from the bottom of the leg and place the middle of the leg wrap on, smoothing it out all the way to the top of the leg
  • Smooth the leg wrap over onto one side, then also on the other side until fully sealed
  • Repeat again on all other legs
  • Secure 2 legs facing up at the front of chair and 2 legs facing down at the back of the chair

CUSHIONS & CUSHION COVERS

  • Wash in a laundry bag
  • Machine wash max. 30 degrees celsius
  • Do not bleach or tumble dry
  • Iron on low heat max. 30 degrees celsius
  • Wash with similar colours with colour safe detergent

FIRST BIRTHDAY OUTFITS

  • Hand wash and steam iron inside out highly recommended